SCA_DelaySensor
Base class: SCA_ISensor
The Delay sensor generates positive and negative triggers at precise time, expressed in number of frames. The delay parameter defines the length of the initial OFF period. A positive trigger is generated at the end of this period.
The duration parameter defines the length of the ON period following the OFF period. There is a negative trigger at the end of the ON period. If duration is 0, the sensor stays ON and there is no negative trigger.
The sensor runs the OFF-ON cycle once unless the repeat option is set: the OFF-ON cycle repeats indefinately (or the OFF cycle if duration is 0).
Use SCA_ISensor.reset at any time to restart sensor.
length of the initial OFF period as number of frame, 0 for immediate trigger.
Type: integer.
duration
Section titled “duration”length of the ON period in number of frame after the initial OFF period.
If duration is greater than 0, a negative trigger is sent at the end of the ON pulse.
Type: integer
repeat
Section titled “repeat”1 if the OFF-ON cycle should be repeated indefinately, 0 if it should run once.
Type: integer
repeatTimes
Section titled “repeatTimes”Number of times the actuator will repeat.
Type: integer.
Not in the Range documentation
Section titled “Not in the Range documentation”These items exist in the engine but were not in the Range documentation. The ones marked new in Anastacio were added by Anastacio Engine.
useDelta
Section titled “useDelta”attribute
Counts the delay in seconds (real time) instead of logic frames.