SCA_ISensor
Base class: SCA_ILogicBrick
Base class for all sensor logic bricks.
usePosPulseMode
Section titled “usePosPulseMode”Flag to turn positive pulse mode on and off.
Type: boolean
useNegPulseMode
Section titled “useNegPulseMode”Flag to turn negative pulse mode on and off.
Type: boolean
frequency
Section titled “frequency”The frequency for pulse mode sensors. (Deprecated: use SCA_ISensor.skippedTicks)
Type: integer
skippedTicks
Section titled “skippedTicks”Number of logic ticks skipped between 2 active pulses
Type: integer
level Option whether to detect level or edge transition when entering a state.
It makes a difference only in case of logic state transition (state actuator).
A level detector will immediately generate a pulse, negative or positive
depending on the sensor condition, as soon as the state is activated.
A edge detector will wait for a state change before generating a pulse.
note: mutually exclusive with tap, enabling will disable tap.
Type: boolean
When enabled only sensors that are just activated will send a positive event,
after this they will be detected as negative by the controllers.
This will make a key thats held act as if its only tapped for an instant.
note: mutually exclusive with level, enabling will disable level.
Type: boolean
invert
Section titled “invert”Flag to set if this sensor activates on positive or negative events.
Type: boolean
triggered
Section titled “triggered”True if this sensor brick is in a positive state. (read-only).
Type: boolean
positive
Section titled “positive”True if this sensor brick is in a positive state. (read-only).
Type: boolean
pos_ticks
Section titled “pos_ticks”The number of ticks since the last positive pulse (read-only).
Type: int
neg_ticks
Section titled “neg_ticks”The number of ticks since the last negative pulse (read-only).
Type: int
status
Section titled “status”The status of the sensor (read-only): can be one of these constants.
Type: int
reset()
Section titled “reset()”Reset sensor internal state, effect depends on the type of sensor and settings.
The sensor is put in its initial state as if it was just activated.
Not in the Range documentation
Section titled “Not in the Range documentation”These items exist in the engine but were not in the Range documentation. The ones marked new in Anastacio were added by Anastacio Engine.
useDeltaTime
Section titled “useDeltaTime”attribute
Uses real time (delta time) for the sensor intervals instead of counting frames.